Cisco Catalyst 3560X-24P Command Reference Manual page 319

Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
Interface
---------
Gi1/0/1
Gi1/0/1
Switch#
This example shows how to enable IP port security with IP-MAC filters on a Layer 2 access port:
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# ip device tracking
Switch(config)# interface gigabitethernet1/0/3
Switch(config-if)# switchport mode access
Switch(config-if)# switchport access vlan 1
Switch(config-if)# ip device tracking maximum 5
Switch(config-if)# switchport port-security
Switch(config-if)# switchport port-security maximum 5
Switch(config-if)# ip verify source tracking port-security
Switch(config-if)# end
Verify your settings by entering the show ip verify source privileged EXEC command.
Related Commands Command
ip device tracking maximum
ip dhcp snooping
ip dhcp snooping limit rate
ip dhcp snooping information
option
ip dhcp snooping trust
ip source binding
show ip dhcp snooping
show ip dhcp snooping binding
show ip verify source
OL-21522-02
Filter-type Filter-mode
----------- -----------
ip-mac active
ip-mac active
Description
Enable IP port security binding tracking on a Layer 2 port.
Globally enable DHCP snooping.
Configure the number of the DHCP messages that an interface
can receive per second.
Enable DHCP option-82 data insertion.
Enable DHCP snooping on a trusted VLAN.
Configure static bindings on the switch.
Display the DHCP snooping configuration.
Display the DHCP snooping binding entries.
Display the IP source guard configuration on the switch or on a
specific interface.
IP-address Mac-address
--------------- -----------------
10.0.0.1
deny-all
End with CNTL/Z.
Catalyst 3750-X and 3560-X Switch Command Reference
ip verify source
Vlan
----------
10
11-20
2-287