Show Stack-Power - Cisco Catalyst 3560X-24P Command Reference Manual

Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands

show stack-power

To display the members of all StackPower stacks or the specified power stack and the power mode of the
stack, use the show stack-power user EXEC command.
Note This command is available only on Catalyst 3750-X switch stacks running the IP base or IP services
image.
Syntax Description stack-id
| begin
| exclude
| include
expression
Command Modes User EXEC
Command History Release
12.2(53)SE2
Usage Guidelines If a switch is shut down because of load shedding, the output of the show stack power command still
includes the MAC address of the shut down neighbor switch. The command output shows the stack
power topology even if there is not enough power to power a switch.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples
This is an example of output from the show stack-power command.
Switch# show stack-power
Power stack name: Powerstack1
OL-21522-02
show stack power [stack-id] [ | {begin | exclude | include} expression]
(Optional) Display power information for the specified power stack. The
stack ID must be 31 characters or less.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Master MAC address: 0022.bdcf.af80
Stack mode: Power sharing
Switch 1:
Power budget: 206
Low port priority value: 11
High port priority value: 10
Switch priority value: 1
Port A status: Not shut
Port B status: Not shut
Neighbor on port A: 0022.bdcf.ab00
Neighbor on port B: 0022.bdd0.6e00
Catalyst 3750-X and 3560-X Switch Command Reference
show stack-power
2-753