Power Inline - Cisco Catalyst 3560X-24P Command Reference Manual

Cisco ios release 12.2(55)se
Hide thumbs Also See for Catalyst 3560X-24P:
Table of Contents

Advertisement

Chapter 2
Catalyst 3750-X and 3560-X Switch Cisco IOS Commands

power inline

To configure the power management mode on Power over Ethernet (PoE) ports, use the power inline
interface configuration command. To return to the default settings, use the no form of this command.
Syntax Description
auto
max max-wattage
never
police
port priority {high | low} Configures the power priority of a StackPower port. In case of a power
static
Defaults
The default is auto (enabled).
The maximum wattage is 30,000 mW.
The default port priority is low.
Command Default
Interface configuration
Command History
Release
12.2(53)SE2
Usage Guidelines
This command is supported only on PoE-capable ports. If you enter this command on a port that does
not support PoE, this error message appears:
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# power inline auto
% Invalid input detected at '^' marker.
In a switch stack, this command is supported on all ports in the stack that support PoE.
OL-21522-02
power inline {auto [max max-wattage] | never | police [action {errdisable | log}] | port priority
{high | low}] | static [max max-wattage]}
no power inline {auto | never | police | port priority| static}
Enables powered-device detection. If enough power is available,
automatically allocates power to the PoE port after device detection.
Allocation is first-come, first-serve.
(Optional) Limits the power allowed on the port. The range is 4000 to
30000 mW. If no value is specified, the maximum is allowed.
Disables device detection, and disable power to the port.
Enables policing of the real-time power consumption. For more
information about these keywords, see the
supply failure, ports configured as low priority are turned off first. The
default priority is low.
Enables powered-device detection. Pre-allocates (reserves) power for a
port before the switch discovers the powered device. This guarantees that
the device connected to the interface receives enough power.
Modification
This command was introduced.
^
power inline police
Catalyst 3750-X and 3560-X Switch Command Reference
power inline
command.
2-449

Advertisement

Table of Contents
loading

Table of Contents