Ipv6 Mld Snooping Last-Listener-Query-Interval - Cisco Catalyst 3560X-24P Command Reference Manual

ipv6 mld snooping last-listener-query-interval

ipv6 mld snooping last-listener-query-interval
Use the ipv6 mld snooping last-listener-query-interval global configuration command on the switch
stack or on a standalone switch to configure IP version 6 (IPv6) Multicast Listener Discovery (MLD)
snooping last-listener query interval on the switch or on a VLAN. This time interval is the maximum
time that a multicast router waits after issuing a Mulitcast Address Specific Query (MASQ) before
deleting a port from the multicast group. Use the no form of this command to reset the query time to the
default settings.
This command is available only if you have configured a dual IPv4 and IPv6 Switch Database
Note
Management (SDM) template on the switch.
Syntax Description vlan vlan-id
integer_value
Command Default The default global query interval (maximum response time) is 1000 (1 second).
The default VLAN query interval (maximum response time) is 0 (the global count is used).
Command Modes Global configuration
Command History Release
12.2(53)SE2
Usage Guidelines To configure the dual IPv4 and IPv6 template, enter the sdm prefer dual-ipv4-and-ipv6 {default | vlan)
global configuration command and reload the switch.
In MLD snooping, when the IPv6 multicast router receives an MLD leave message, it sends out queries
to hosts belonging to the multicast group. If there are no responses from a port to a MASQ for a length
of time, the router deletes the port from the membership database of the multicast address. The last
listener query interval is the maximum time that the router waits before deleting a nonresponsive port
from the multicast group.
When a VLAN query interval is set, this overrides the global query interval. When the VLAN interval
is set at 0, the global value is used.
VLAN numbers 1002 through 1005 are reserved for Token Ring and FDDI VLANs and cannot be used
in MLD snooping.
Catalyst 3750-X and 3560-X Switch Command Reference
2-304
ipv6 mld snooping [vlan vlan-id] last-listener-query-interval integer_value
no ipv6 mld snooping [vlan vlan-id] last-listener-query-interval
(Optional) Configure last-listener query interval on the specified VLAN. The
VLAN ID range is 1 to 1001 and 1006 to 4094.
Set the time period (in thousands of a second) that a multicast router to wait
after issuing a MASQ before deleting a port from the multicast group. The
range is 100 to 32,768. The default is 1000 (1 second),
Modification
This command was introduced.
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
OL-21522-02