Show Controllers Ethernet-Controller Fastethernet - Cisco Catalyst 3560X-24P Command Reference Manual

Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands

show controllers ethernet-controller fastethernet

Use the show controllers ethernet-controller fastethernet privileged EXEC command to display
information about the Ethernet management port, including the port status and the per-interface send and
receive statistics read from the hardware.
Syntax Description phy [detail]
stack
| begin
| exclude
| include
expression
Command Modes
Privileged EXEC (only supported with the fastethernet 0 keywords in user EXEC mode)
Command History Release
12.2(53)SE2
Usage Guidelines
The output display provides information that might be useful for Cisco technical support representatives
troubleshooting the switch.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
OL-21522-02
show controllers ethernet-controller fastethernet 0 [phy [detail] | stack] [ | {begin | exclude |
include} expression]
(Optional) Display the status of the internal registers on the switch physical layer
device (PHY) for the Ethernet management port on the switch when the command
is entered on a standalone switch.
Display the status of the internal registers on the switch PHYs for all the Ethernet
management ports in the switch stack when the command is entered on a stack
master or member switch in a mixed stack. The port information appears only for
the Catalyst 3750-E or Catalyst 3750-X switches in the stack.
Use the detail keyword to display details about the PHY internal registers.
This display includes the operational state of the automatic medium-dependent
interface crossover (auto-MDIX) feature on an interface.
(Optional) Display the speed, duplex mode, and link states of the Ethernet
management ports in the switch stack when the command is entered on a stack
master or member switch in a stack. The port information appears only for the
Catalyst 3750-E or Catalyst 3750-X switches in the stack.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
show controllers ethernet-controller fastethernet
Catalyst 3750-X and 3560-X Switch Command Reference
2-543