Cisco Catalyst 3560X-24P Command Reference Manual page 621

Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
backup
tengigabitethernet
transceiver [detail |
properties |
dom-supported-list]
trunk
| begin
| exclude
| include
expression
Though visible in the command-line help strings, the crb, fair-queue, irb, mac-accounting,
Note
precedence, random-detect, rate-limit, and shape keywords are not supported.
Command Modes Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines The show interfaces capabilities command with different keywords has these results:
•
•
•
•
•
•
•
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
OL-21522-02
(Optional) Display Flex Link backup interface configuration and status for
the specified interface or all interfaces on the switch or the stack.
Display the status of a connected ten-gigabit module.
See the
Display interface trunk information. If you do not specify an interface, only
information for active trunking ports appears.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
On Catalyst 3750-X switches, use the show interface capabilities module number command to
display the capabilities of all interfaces on that switch in the stack. If there is no switch with that
module number in the stack, there is no output.
On Catalyst 3560-X switches, use the show interface capabilities module 1 command to display
the capabilities of all interfaces on the switch. Any other number is invalid.
Use the show interfaces interface-id capabilities to display the capabilities of the specified
interface.
On Catalyst 3750-X switches, use the show interfaces capabilities (with no module number or
interface ID) to display the capabilities of all interfaces in the stack.
On Catalyst 3560-X switches, use the show interfaces capabilities (with no module number or
interface ID) to display the capabilities of all interfaces on the switch.
On Catalyst 3750-X switches, use the show interface switchport module number command to
display the switch port characteristics of all interfaces on that switch in the stack. If there is no
switch with that module number in the stack, there is no output.
On Catalyst 3560-X switches, use the show interface switchport module 1 to display the switch
port characteristics of all interfaces on the switch. Any other number is invalid.
show interfaces transceivers
Catalyst 3750-X and 3560-X Switch Command Reference
show interfaces
command.
2-589