Cisco Catalyst 3560X-24P Command Reference Manual page 895

Cisco ios release 12.2(55)se

Hide thumbs Also See for Catalyst 3560X-24P:

Table of Contents

Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands

When you use this command, memory is allocated for the provisioned configuration. When a new switch

type is configured, the previously allocated memory is not fully released. Therefore, do not use this

command more than approximately 200 times, or the switch will run out of memory and unexpected

behavior will result.

This example shows how to provision a switch with a stack member number of 2 for the switch stack.

The show running-config command output shows the interfaces associated with the provisioned switch:

Switch(config)# switch 2 provision WS- xxxx

Switch(config)# end

Switch# show running-config | include switch 2

interface GigabitEthernet2/0/1

interface GigabitEthernet2/0/2

interface GigabitEthernet2/0/3

You also can enter the show switch user EXEC command to display the provisioning status of the switch

This example shows how to delete all configuration information about a stack member 5 when the switch

is removed from the stack:

Switch(config)# no switch 5 provision

You can verify that the provisioned switch is added to or removed from the running configuration by

entering the show running-config privileged EXEC command.

Related Commands

show running-config

Displays the operating configuration. For syntax information, use this link to

the Cisco IOS Release 12.2 Command Reference listing page:

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_command

_reference_list.html

Select the Cisco IOS Commands Master List, Release 12.2 to navigate to

the command.

Displays information about the switch stack and its stack members.

Catalyst 3750-X and 3560-X Switch Command Reference

switch provision