Cisco Catalyst 3560X-24P Command Reference Manual page 822

snmp-server enable traps
syslog
tty
vlan-membership
vlancreate
vlandelete
vtp
Though visible in the command-line help strings, the fru-ctrl, insertion, and removal keywords are not
Note
supported on Catalyst 3560-X switches.
The snmp-server enable informs global configuration command is not supported. To enable the
sending of SNMP inform notifications, use the snmp-server enable traps global configuration
command combined with the snmp-server host host-addr informs global configuration command.
Defaults The sending of SNMP traps is disabled.
Command Modes Global configuration
Command History Release
12.2(53)SE2
Usage Guidelines Specify the host (NMS) that receives the traps by using the snmp-server host global configuration
command. If no trap types are specified, all trap types are sent.
When supported, use the snmp-server enable traps command to enable sending of traps or informs.
Informs are not supported in SNMPv1.
Note
To enable more than one type of trap, you must enter a separate snmp-server enable traps command
for each trap type.
Examples This example shows how to send VTP traps to the NMS:
Switch(config)# snmp-server enable traps vtp
You can verify your setting by entering the show vtp status or the show running-config privileged
EXEC command.
Catalyst 3750-X and 3560-X Switch Command Reference
2-790
(Optional) Enable SNMP syslog traps.
(Optional) Send TCP connection traps. This is enabled by default.
(Optional) Enable SNMP VLAN membership traps.
(Optional) Enable SNMP VLAN-created traps.
(Optional) Enable SNMP VLAN-deleted traps.
(Optional) Enable VLAN Trunking Protocol (VTP) traps.
Modification
This command was introduced.
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
OL-21522-02