Network-Policy - Cisco Catalyst 3560X-24P Command Reference Manual

network-policy

network-policy
Use the network-policy interface configuration command to apply a network-policy profile to an
interface. Use the no form of this command to remove the policy.
Syntax Description
profile number
Defaults No network-policy profiles are applied.
Command Modes Interface configuration
Command History Release
12.2(53)SE2
Usage Guidelines Use the network-policy profile number interface configuration command to apply a profile to an
interface.
If you first configure a network-policy profile on an interface, you cannot apply the switchport voice
vlan command on the interface. If switchport voice vlan vlan-id is already configured on an interface,
you can apply a network-policy profile on the interface. The interface then has the voice or
voice-signaling VLAN network-policy profile applied on the interface.
Examples
This example shows how to apply network-policy profile 60 to an interface:
Switch(config)# interface_id
Switch(config-if)# network-policy 60
Related Commands Command
network-policy profile (global
configuration)
network-policy profile
(network-policy configuration)
show network-policy profile
Catalyst 3750-X and 3560-X Switch Command Reference
2-414
network-policy profile number
no network-policy
Modification
This command was introduced.
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
Specify the network-policy profile number.
Description
Creates the network-policy profile.
Configures the attributes of network-policy profiles.
Displays the configured network-policy profiles.
OL-21522-02