Debug Qos-Manager - Cisco Catalyst 3560X-24P Command Reference Manual

debug qos-manager

debug qos-manager
Use the debug qos-manager privileged EXEC command to enable debugging of the quality of service
(QoS) manager software. Use the no form of this command to disable debugging.
Syntax Description
all
event
verbose
Defaults Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines
The undebug qos-manager command is the same as the no debug qos-manager command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
show debugging
Catalyst 3750-X and 3560-X Switch Command Reference
B-84
debug qos-manager {all | event | verbose}
no debug qos-manager {all | event | verbose}
Display all QoS-manager debug messages.
Display QoS-manager related-event debug messages.
Display QoS-manager detailed debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
OL-21522-02