Cisco Catalyst 3560X-24P Command Reference Manual page 1060

debug platform ip igmp snooping
rpc [cfg | l3mm | misc
| vlan]
warn
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines The undebug platform ip igmp snooping command is the same as the no debug platform ip igmp
snooping command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
debug ip igmp
snooping
show debugging
Catalyst 3750-X and 3560-X Switch Command Reference
B-52
Appendix B
Display IGMP snooping remote procedure call (RPC) event debug messages.
The keywords have these meanings:
cfg—(Optional) Display IGMP snooping RPC debug messages.
•
l3mm—(Optional) IGMP snooping Layer 3 multicast router group RPC
•
debug messages.
misc—(Optional) IGMP snooping miscellaneous RPC debug messages.
•
vlan—(Optional) IGMP snooping VLAN assert RPC debug messages.
•
Display IGMP snooping warning messages.
Modification
This command was introduced.
Description
Displays information about platform-independent IGMP snooping activity.
Displays information about the types of debugging that are enabled.
Catalyst 3750-X and 3560-X Switch Debug Commands
OL-21522-02