Cisco Catalyst 3560X-24P Command Reference Manual page 901

Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
These restrictions apply to dynamic-access ports:
•
•
•
•
•
Examples
This example shows how to change a switched port interface that is operating in access mode to operate
in VLAN 2 instead of the default VLAN:
Switch(config-if)# switchport access vlan 2
You can verify your setting by entering the show interfaces interface-id switchport privileged EXEC
command and examining information in the Administrative Mode and Operational Mode rows.
Related Commands Command
show interfaces
switchport mode
OL-21522-02
The software implements the VLAN Query Protocol (VQP) client, which can query a VMPS such
as a Catalyst 6000 series switch. The Catalyst 3750-X and 3560-X switches are not VMPS servers.
The VMPS server must be configured before a port is configured as dynamic.
Use dynamic-access ports only to connect end stations. Connecting them to switches or routers (that
use bridging protocols) can cause a loss of connectivity.
Configure the network so that STP does not put the dynamic-access port into an STP blocking state.
The Port Fast feature is automatically enabled on dynamic-access ports.
Dynamic-access ports can only be in one VLAN and do not use VLAN tagging.
Dynamic-access ports cannot be configured as
Members of an EtherChannel port group (dynamic-access ports cannot be grouped with any
–
other port, including other dynamic ports).
Source or destination ports in a static address entry.
–
– Monitor ports.
switchport
Description
Displays the administrative and operational status of a switching
(nonrouting) port, including port blocking and port protection settings.
Configures the VLAN membership mode of a port.
Catalyst 3750-X and 3560-X Switch Command Reference
switchport access
2-869