Debug Mka - Cisco Catalyst 3560X-24P Command Reference Manual

Cisco ios release 12.2(55)se

Hide thumbs Also See for Catalyst 3560X-24P:

Table of Contents

debug mka

To enable debugging of the MACsec Key Agreement (MKA) protocol sessions, use the debug mka

privileged EXEC command. To disable debugging, use the no form of this command.

Syntax Description

MKA debugging is disabled.

Command Modes

Privileged EXEC

Command History

Usage Guidelines

Entering the debug mka command with no keywords enables all MKA debugging facilities.

The undebug backup command is the same as the no debug backup command.

When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack

member, you can start a session from the stack master by using the session switch-number privileged

EXEC command. Then enter the debug command at the command-line prompt of the stack member. You

also can use the remote command stack-member-number LINE privileged EXEC command on the stack

master switch to enable debugging on a member switch without starting a session.

Catalyst 3750-X and 3560-X Switch Command Reference

(Optional) Displays MKA errors that occur during normal MKA operation. You

can use this command for verification of MKA sessions.

(Optional) Displays MKA debugging messages for significant events that occur

during MKA operation. You can use this command for verification of MKA

(Optional) Displays MKA debugging messages for events passing through the

LinkSec Layer Interface (LLI) to see the interaction between MKA and

Authentication manager.

(Optional) Displays MKA debugging messages for events passing through the

MACSec Layer Interface (lli) to see the interaction between MKA and MACsec.

(Optional) Displays MKA debugging messages for MKPDU transmissions and

receptions during normal MKA operation.

(Optional) Displays MKA debugging messages for tracing the normal operation

of MKA sessions.

Modification

This command was introduced.

Catalyst 3750-X and 3560-X Switch Debug Commands