Debug Ip Igmp Max-Groups - Cisco Catalyst 3560X-24P Command Reference Manual

debug ip igmp max-groups

debug ip igmp max-groups
Use the debug ip igmp max-groups privileged EXEC command to enable debugging of Internet Group
Management Protocol (IGMP) maximum groups events. Use the no form of this command to disable
debugging.
Syntax Description
This command has no arguments or keywords.
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines The undebug ip igmp max-groups command is the same as the no debug ip igmp max-groups
command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
show debugging
Catalyst 3750-X and 3560-X Switch Command Reference
B-20
debug ip igmp max-groups
no debug ip igmp max-groups
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
OL-21522-02