Cisco Catalyst 3560X-24P Command Reference Manual page 160

cluster standby-group
This example shows the error message when this command is executed on a cluster command switch and
the specified HSRP standby group does not exist:
Switch(config)# cluster standby-group my_hsrp
%ERROR: Standby (my_hsrp) group does not exist
This example shows the error message when this command is executed on a cluster member switch:
Switch(config)# cluster standby-group my_hsrp routing-redundancy
%ERROR: This command runs on a cluster command switch
You can verify your settings by entering the show cluster privileged EXEC command. The output shows
whether redundancy is enabled in the cluster.
Related Commands Command
standby ip
show cluster
show standby
Catalyst 3750-X and 3560-X Switch Command Reference
2-128
Chapter 2
Description
Enables HSRP on the interface. For syntax information, select Cisco IOS IP
Command Reference, Volume 1 of 3:Addressing and Services,
Release 12.2 > IP Services Commands.
Displays the cluster status and a summary of the cluster to which the switch
belongs.
Displays standby group information. For syntax information, select Cisco
IOS IP Command Reference, Volume 1 of 3:Addressing and Services,
Release 12.2 > IP Services Commands.
Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
OL-21522-02