Nsf - Cisco Catalyst 3560X-24P Command Reference Manual

Cisco ios release 12.2(55)se
Hide thumbs Also See for Catalyst 3560X-24P:
Table of Contents

Advertisement

Chapter 2
Catalyst 3750-X and 3560-X Switch Cisco IOS Commands

nsf

Use the nsf router configuration command on a switch stack or standalone switch to enable and configure
Cisco nonstop forwarding (NSF) for Open Shortest Path First (OSPF) or Enhanced Interior Gateway
Routing Protocol (EIGRP) routing. Use the no form of this command to disable NSF.
This command is not supported on switches running the LAN base feature set.
Note
Syntax Description
enforce global
Defaults
NSF is disabled.
The enforce global option is enabled (OSPF only).
Command Modes
Router configuration (OSPF or EIGRP)
Command History
Release
12.2(53)SE2
Usage Guidelines
The nsf command is a router configuration command and affects all interfaces that are covered by the
designated routing process. The switch supports Cisco NSF for OSPF and EIGRP protocols.
When NSF is enabled and a stack master switchover is detected, the NSF-capable routers rebuild routing
information from NSF-aware or NSF-capable neighbors and do not wait for a restart.
Examples
This example shows how to enable OSPF NSF:
Switch(config)# router ospf 100
Switch(config-router)# nsf
Use the show ip ospf privileged EXEC command to verify that OSPF NSF is enabled.
This example shows how to enable EIGRP NSF:
Switch(config)# router eigrp 1
Switch(config-router)# nsf
Use the show ip protocols privileged EXEC command to verify that EIGRP NSF is enabled.
OL-21522-02
nsf [enforce global]
no nsf
(Optional) Cancel OSPF NSF restart when non-NSF-aware neighbors are
detected. These keywords are visible only in OSPF router configuration
mode.
Modification
This command was introduced.
Catalyst 3750-X and 3560-X Switch Command Reference
nsf
2-423

Advertisement

Table of Contents
loading

Table of Contents