Cisco Catalyst 3560X-24P Command Reference Manual page 439

Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
This example shows how to configure the destination port for ingress traffic on VLAN 5 by using a
security device that supports IEEE 802.1Q encapsulation. Egress traffic replicates the source; ingress
traffic uses IEEE 802.1Q encapsulation.
Switch(config)# monitor session 2 destination interface gigabitethernet1/0/2 encapsulation
dot1q ingress dot1q vlan 5
This example shows how to configure the destination port for ingress traffic on VLAN 5 by using a
security device that does not support encapsulation. Egress traffic and ingress traffic are untagged.
Switch(config)# monitor session 2 destination interface gigabitethernet1/0/2 ingress
untagged vlan 5
You can verify your settings by entering the show monitor privileged EXEC command. You can display
SPAN, RSPAN, FSPAN, and FRSPAN configuration on the switch by entering the show running-config
privileged EXEC command. SPAN information appears near the end of the output.
Related Commands Command
remote-span
show monitor
show running-config
OL-21522-02
Description
Configures an RSPAN VLAN in vlan configuration mode.
Displays SPAN and RSPAN session information.
Displays the operating configuration. For syntax information, use
this link to the Cisco IOS Release 12.2 Command Reference listing
page:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_co
mmand_reference_list.html
Select the Cisco IOS Commands Master List, Release 12.2 to
navigate to the command.
Catalyst 3750-X and 3560-X Switch Command Reference
monitor session
2-407