Clear Errdisable Interface - Cisco Catalyst 3560X-24P Command Reference Manual

clear errdisable interface

clear errdisable interface
Use the clear errdisable interface privileged EXEC command on the switch stack or on a standalone
switch to re-enable a VLAN that was error disabled.
clear errdisable interface interface-id vlan [vlan-list]
Syntax Description vlan list
Command Default No default is defined
Command Modes
Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines
You can re-enable a port by using the shutdown and no shutdown interface configuration commands,
or you can clear error disable for VLANs by using the clear errdisable interface command.
Examples This example shows how to re-enable all VLANs that were error-disabled on Gigabit Ethernet port 4/0/2.
Switch#
Related Commands Command
errdisable detect cause
errdisable recovery
show errdisable detect
show errdisable recovery
show interfaces
err-disabled
Catalyst 3750-X and 3560-X Switch Command Reference
2-94
(Optional) Specify a list of VLANs to be re-enabled. If a vlan-list is not
specified, then all VLANs are re-enabled.
Modification
This command was introduced.
clear errdisable interface gigabitethernet4/0/2 vlan
Description
Enables error-disabled detection for a specific cause or all causes.
Configures the recovery mechanism variables.
Displays error-disabled detection status.
Display error-disabled recovery timer information.
status Displays interface status of a list of interfaces in error-disabled state.
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
OL-21522-02