Jump And Jump End: Jmp(004) And Jme - Omron SYSMAC CJ - REFERENCE MANUAL 08-2008 Reference Manual

Sequence Control Instructions
W00000
MILH
010000
000200
000001
W00001
MILH
010001
H0000
000002
SET
000003
MILC
CNT
MILC
3-5-6

JUMP and JUMP END: JMP(004) and JME(005)

Purpose
Ladder Symbols
Variations
228
When W00000 is OFF, the instructions between MILH(517) with interlock
number 0 and MILC(519) with interlock number 0 are interlocked.
When W00000 is ON and W00001 are OFF, the instructions between
MILH(517) with interlock number 1 and MILC(519) with interlock number 1 are
interlocked. The other instructions are executed normally.
W00000 and W00001
both ON
0
1
Executed
normally.
1
1
#0010
0
When the execution condition for JMP(004) is OFF, program execution jumps
directly to the first JME(005) in the program with the same jump number.
JMP(004) and JME(005) are used in pairs.
JMP(004)
N
JME(005)
N
Variations Jumps when OFF/Does Not Jump when ON
Immediate Refreshing Specification
W00000 ON and W00001
W0000 OFF
OFF
OFF
OFF
Outputs
interlocked.
Held
Held
N: Jump number
N: Jump number
Section 3-5
Executed
normally.
Outputs
interlocked.
Executed
normally.
JMP(004)
Not supported