Sequence Control Instructions; End: End(001) - Omron SYSMAC CJ - REFERENCE MANUAL 08-2008 Reference Manual

Sequence Control Instructions

Example
3-5 Sequence Control Instructions
3-5-1

END: END(001)

Purpose
Ladder Symbol
Variations
Applicable Program Areas
206
the same time as it writes the status of the execution condition (power flow) to
the specified output bit in I/O memory.
When OUTB(534) is programmed between IL(002) and ILC(003), the speci-
fied bit will be turned OFF if the program section is interlocked. (This is the
same as an OUT instruction in an interlocked program section.)
When a word is specified for the bit number (N), only bits 00 to 03 of N are
used. For example, if N contains FFFA hex, OUTB(534) will control bit 10 of
word D.
Note Difference between SETB(532)/RSTB(533) and OUTB(534)
For OUTB(534), the operand bit is turned ON when the input condition turns
ON and is turned OFF when the input condition turns OFF. For SETB(532)
and RSTB(533), the operand bit turns ON or OFF, respectively, when the input
condition turns ON and the operand bit does not change when the input con-
dition turns OFF.
000000
Note Precaution for Index Registers
OUTB(534) is executed even when the input condition turns OFF. Be particu-
larly careful when programming OUT using an indirect index register address.
Input condition
Indicates the end of a program.
END(001)
Variations Executed Each Cycle for ON Condition
Immediate Refreshing Specification
Block program areas
Not allowed
OUTB
Bit 10 of D00000 is turned OFF
D00000
when CIO 000000 is OFF.
&10
MOVR
D100
IR0
When the input condition is OFF,
OUTB
MOVR(560) is not executed, but
,IR0
OUTB(534) is executed for the address
&15
stored in the index register.
Step program areas
Not allowed
Section 3-5
END(001)
Not supported
Subroutines Interrupt tasks
Not allowed OK