Omron SYSMAC CJ - REFERENCE MANUAL 08-2008 Reference Manual page 239

Sequence Output Instructions
Operand Specifications
Description
Note The bits being turned ON or OFF must be in the same data area. (The range
of words is roughly D to D+N2 16.)
Area
CIO Area
Work Area
Holding Bit Area
Auxiliary Bit Area
Timer Area
Counter Area
DM Area
EM Area without bank
EM Area with bank
Indirect DM/EM addresses in
binary
Indirect DM/EM addresses in
BCD
Constants
Data Registers
Index Registers
Indirect addressing using
Index Registers
The operation of SETA(530) and RSTA(531) are described separately below.
Operation of SETA(530)
SETA(530) turns ON N2 bits, beginning from bit N1 of D, and continuing to the
left (more-significant bits). All other bits are left unchanged. (No changes will
be made if N2 is set to 0.)
Bits turned ON by SETA(530) can be turned OFF by any other instructions,
not just RSTA(531).
D
to
D: 256 words max.
D
CIO 0000 to CIO 6143
W000 to W511
H000 to H511
A448 to A959
T0000 to T4095
C0000 to C4095
D00000 to D32767
E00000 to E32767
En_00000 to En_32767
(n = 0 to C)
@ D00000 to @ D32767
@ E00000 to @ E32767
@ En_00000 to @ En_32767
(n = 0 to C)
*D00000 to *D32767
*E00000 to *E32767
*En_00000 to *En_32767
(n = 0 to C)
---
---
---
,IR0 to ,IR15
–2048 to +2047, IR0 to –2048 to +2047, IR15
DR0 to DR15, IR0 to IR15
,IR0+(++) to ,IR15+(++)
,–(– –) IR0 to, –(– –) IR15
Section 3-4
N1 N2
A000 to A959
#0000 to #000F #0000 to #FFFF
(binary) or &0 to (binary) or &0 to
&15 &65535
DR0 to DR15
199