Omron SYSMAC CJ - REFERENCE MANUAL 08-2008 Reference Manual page 570

Conversion Instructions
Operand Specifications
530
S: Source Word
Contains the gray binary code to be converted. The range must be within the
number of bits determined by the resolution specified in bits 00 to 03 of C. All
bits outside of the number of bits for the specified resolution will be ignored.
For example, if the specified resolution is 08 hex and S contains FFFF hex,
the gray binary code will be taken as 00FF hex.
S
D: First destination word
Destination words D+1 and D contain the results of converting the gray binary
code at the resolution specified in bits 00 to 03 of the control data word C and
the conversion mode specified in bits 04 to 07 of the control data word C. The
leftmost word is output to D+1 and the rightmost word is output to D. The
ranges of data that are output are as follows:
Binary Mode: 0000 0000 to 0000 7FFF hex
BCD Mode: 0000 0000 to 0003 2767
360 Mode: 0000 0000 to 0000 3599
(0.0 to 359.9 in 0.1 increments, BCD)
Rightmost word
D
D+1 Leftmost word
Area
CIO Area
Work Area
Holding Bit Area
Auxiliary Bit Area
Timer Area
Counter Area
DM Area
EM Area without bank
EM Area with bank
Indirect DM/EM
addresses in binary
Indirect DM/EM
addresses in BCD
Constants
Data Registers
C
CIO 0000 to CIO 0000 to
CIO 6142 CIO 6143
W000 to W510 W000 to W511
H000 to H510 H000 to H511
A000 to A958 A000 to A959
T0000 to T4094 T0000 to T4095
C0000 to C4094 C0000 to C4095
D00000 to D00000 to
D32766 D32767
E00000 to E00000 to
E32766 E32767
En_00000 to En_00000 to
En_32766 En_32767
(n = 0 to C) (n = 0 to C)
@ D00000 to @ D32767
@ E00000 to @ E32767
@ En_00000 to @ En_32767
(n = 0 to C)
*D00000 to *D32767
*E00000 to *E32767
*En_00000 to *En_32767
(n = 0 to C)
--- #0000 to #FFFF
(binary)
--- DR0 to DR15
Section 3-12
S D
CIO 0000 to
CIO 6142
W000 to W510
H000 to H510
A448 to A958
T0000 to T4094
C0000 to C4094
D00000 to
D32766
E00000 to
E32766
En_00000 to
En_32766
(n = 0 to C)
---
---