Omron SYSMAC CJ - REFERENCE MANUAL 08-2008 Reference Manual page 273

Sequence Control Instructions
Applicable Program Areas
Operands
Operand Specifications
Description
Variations Jumps when OFF/Does Not Jump when ON
Immediate Refreshing Specification
Variations Executed Each Cycle for ON Condition
Immediate Refreshing Specification
Block program areas
OK
N: Jump Number
The jump number must be 0000 to 03FF (0 to 1,023 decimal).
Note For CJ1M-CPU11 and CJ1M-CPU21 CPU Units, the jump number must be
between the range 0000 to 00FF hex or &0 to &255 decimal.
Area
CIO Area
Work Area
Holding Bit Area
Auxiliary Bit Area
Timer Area
Counter Area
DM Area
EM Area without
bank
EM Area with bank
Indirect DM/EM
addresses in binary
Indirect DM/EM
addresses in BCD
Constants
Data Registers
Index Registers
Indirect addressing
using Index Regis-
ters
Note For CJ1M-CPU11 and CJ1M-CPU21 CPU Units, the range is #0000 to #00FF
(binary) or &0 to &1023 (decimal).
The operation of CJP(510) and CJPN(511) differs only in the execution condi-
tion. CJP(510) jumps to the first JME(005) when the execution condition is ON
Step program areas
Not allowed
CJP(510) CJPN(511)
CIO 0000 to CIO 6143
W000 to W511
H000 to H511
A000 to A959
T0000 to T4095
C0000 to C4095
D00000 to D32767
E00000 to E32767
En_00000 to En_32767
(n = 0 to C)
@ D00000 to @ D32767
@ E00000 to @ E32767
@ En_00000 to @ En_32767
(n = 0 to C)
*D00000 to *D32767
*E00000 to *E32767
*En_00000 to *En_32767
(n = 0 to C)
#0000 to #03FF (binary) or &0 to &1023
(See note.)
DR0 to DR15
---
,IR0 to ,IR15
–2048 to +2047, IR0 to –2048 to +2047,
IR15
DR0 to DR15, IR0 to IR15
Section 3-5
CJPN(511)
Not supported
JME(005)
Not supported
Subroutines Interrupt tasks
OK OK
N
JME(005)
---
---
---
---
---
---
---
---
---
---
---
#0000 to #03FF
(binary) or &0 to
&1023 (See note.)
---
---
---
233