Xerox ColorQube 9303 Series Service Manual page 1733

DADH Feed clutch
CL005-062
Figure 2 DADH component location
Covers
The DADH covers set consist of four main enclosures:
• the top cover assembly,
• the baffle assembly,
• the rear cover and
• input tray.
The top cover assembly pivots on the left for jam clearance to the upper paper path. Access to
the exit/duplex paper path is achieved through the baffle assembly, which can be opened after
raising the DADH. Access to the drives requires the removal of the rear cover. Access to the
input tray components requires removal of the input tray. The top cover assembly and baffle
assembly are for customer access to jam clearance areas. Access inside all other covers
requires the removal of screws and is intended for Xerox service personnel only.
Interlocks
The DADH top cover interlock switch, S005-212, is located at the rear of the DADH. This sup-
plies the DADH PWB with +24V for clutches solenoids and motors. There is no +24V indicator
on the DADH PWB.
ColorQube® 9303 Family
Top cover
interlock
switch
S005-212
CVT motor
MOT005-099
DADH Feed
motor
MOT005-074
February 2013
The platen down sensor, Q062-019, is located at the front of the scanner module. It is actuated
by a magnet at the front of the DADH. It is not a power interlock, but it monitors of the DADH
open or closed condition.
The angle sensor, Q062-301, is located in the scanner module. It detects that the DADH is cur-
rently open more or less than a fixed angle.
8-39
Principles of Operation