4-Dw Gpu Model / 8-Dw Gpu Model; Components; 2.5-Inch Hot-Swap Drive Replacement - Lenovo ThinkSystem SR675 V3 User Manual

Step 1. Ensure that the cover latch is in the open position. Lower the top cover onto the chassis until
both sides of the top cover engage the guides on both sides of the chassis. Then, slide the top
cover to the front of the chassis until the top cover snaps into position.
Step 2. Press down the cover latch to lock the top cover in place.
Figure 118. Top cover installation
After you finish
Complete the parts replacement. See
4-DW GPU Model / 8-DW GPU Model components
Follow instructions in this section to remove and install the 4-DW GPU Model and 8-DW GPU Model

components.

2.5-inch hot-swap drive replacement

Follow instructions in this section to remove and install a 2.5-inch hot-swap drive.
Remove a 2.5-inch hot-swap drive
Follow instructions in this section to remove a 2.5-inch hot-swap drive.
About this task
Attention:
• Read "Installation Guidelines" on page 45
work safely.
• To make sure that there is adequate system cooling, do not operate the server for more than two minutes
without either a drive or a filler installed in each bay.
ThinkSystem SR675 V3 User Guide
156
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 46
194.
to ensure that you