Cmos Battery (Cr2032) Replacement - Lenovo ThinkSystem SR675 V3 User Manual

CMOS battery (CR2032) replacement

Follow instructions in this section to remove and install the CMOS battery (CR2032).
Remove the CMOS battery (CR2032)
Follow instructions in this section to remove the CMOS battery (CR2032).
• Lenovo has designed this product with your safety in mind. The lithium battery must be handled correctly
to avoid possible danger. If you replace the battery, you must adhere to the following instructions.
• If you replace the original lithium battery with a heavy-metal battery or a battery with heavy-metal
components, be aware of the following environmental consideration. Batteries and accumulators that
contain heavy metals must not be disposed of with normal domestic waste. They will be taken back free
of charge by the manufacturer, distributor, or representative, to be recycled or disposed of in a proper
manner.
• After you replace the battery, you must reconfigure the server and reset the system date and time.
S004
CAUTION:
When replacing the lithium battery, use only Lenovo specified part number or an equivalent type
battery recommended by the manufacturer. If your system has a module containing a lithium battery,
replace it only with the same module type made by the same manufacturer. The battery contains
lithium and can explode if not properly used, handled, or disposed of.
Do not:
• Throw or immerse into water
• Heat to more than 100°C (212°F)
• Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
S005
CAUTION:
The battery is a lithium ion battery. To avoid possible explosion, do not burn the battery. Exchange it
only with the approved part. Recycle or discard the battery as instructed by local regulations.
About this task
Attention:
• Read "Installation Guidelines" on page 45
work safely.
and "Safety inspection checklist" on page 46
Chapter 5
to ensure that you
.
Hardware replacement procedures
69