a.
Insert the front I/O module into the front I/O module slot. Ensure that the module is fully
seated.
b.
Fasten the front I/O module retention screw.
Figure 50. Front I/O module installation
Step 3.
Connect the front USB, video and external diagnostics handset cables from the front I/O module to
their respective connectors on the system board assembly.
Notes: Refer to the front I/O module cable routing guide for each server model below.
• For the 4-DW GPU Model, see
After you finish
Complete the parts replacement. See
Front operator panel replacement
Follow instructions in this section to remove or install the front operator panel.
Remove the front operator panel
Follow instructions in this section to remove the front operator panel.
About this task
Attention:
• Read
"Installation Guidelines" on page 45
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
"Front I/O module cable routing" on page
"Complete the parts replacement" on page
and
"Safety inspection checklist" on page 46
54.
202.
194.
.
Chapter 5
Hardware replacement procedures
to ensure that you
85