Figure 137. E1.S drive backplane installation
After you finish
1. Reinstall the E1.S drive cage assembly. See
2. Reconnect the power and signal cables to the E1.S drive backplane.
3. Reinstall the E1.S hot-swap drives or drive bay fillers (if any) into the drive bays. See
S hot-swap drive" on page
4. Complete the parts replacement. See
ES.3 drive backplane module replacement
Follow instructions in this section to remove and install the ES.3 drive backplane module.
Remove the E3.S drive backplane module
Follow instructions in this section to remove the E3.S drive backplane module.
About this task
Attention:
• Read
"Installation Guidelines" on page 45
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack. See
Watch the procedure
A video of this procedure is available at YouTube:
AgTVLhsU24Nhel3_oYlnGT
Procedure
Step 1.
Make preparation for this task.
ThinkSystem SR675 V3 User Guide
172
"Install the E1.S / ES.3 drive cage assembly" on page
166.
"Complete the parts replacement" on page
and
"Safety inspection checklist" on page 46
54.
"Remove the server from rack" on page
.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
178.
"Install an E1.S / E3.
194.
to ensure that you
54.