Figure 114. System board assembly installation
Step 2.
(Optional) If you are going to replace the system I/O board, install the firmware and RoT security
module that is removed from the old system I/O board onto the new system I/O board. See
the firmware and RoT security module" on page
Step 3.
Place the system board assembly inside the chassis.
a.
Grasp the two lifting handles on the system board assembly, and tilt the system board
assembly so that its rear end is up.
b.
Lower the system board assembly into the chassis.
Figure 115. System board assembly installation
ThinkSystem SR675 V3 User Guide
148
139.
"Install