Figure 132. EDSFF drive cage cover removal
Step 2.
If the drive bay contains a filler, pull the release lever on the filler and slide it out of the bay.
Step 3.
Install the E1.S or E3.S hot-swap drive.
a.
Make sure that the drive handle is in the open position. Then, align the drive with the guide
rails in the bay and gently slide the drive into the bay until it stops.
b.
Rotate the drive handle to the fully closed position until the handle latch clicks.
Figure 133. E1.S hot-swap drive installation
ThinkSystem SR675 V3 User Guide
168