Lenovo ThinkSystem SR675 V3 User Manual page 130

Attention:
• Read "Installation Guidelines" on page 45
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack. See
Watch the procedure
A video of this procedure is available at YouTube:
AgTVLhsU24Nhel3_oYlnGT
Procedure
Step 1. Make preparation for this task.
a. Remove the top cover. See
b. Remove all of the power supply units. See
Step 2. Remove the power distribution board.
a. Remove the three screws from the power distribution board.
b. Lift the power distribution board out of its connector.
Figure 89. Power distribution board removal
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the power distribution board
Follow instructions in this section to install the power distribution board.
ThinkSystem SR675 V3 User Guide
122
and "Safety inspection checklist" on page 46
54.
"Remove the server from rack" on page
.
"Remove the top cover" on page
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
154.
"Remove a power supply unit" on page
to ensure that you
54.
123.