Lenovo ThinkSystem SR675 V3 User Manual page 165

• If one or more NVMe solid-state drives are to be removed, it is recommended to disable them beforehand
via the operating system.
• Before you remove or make changes to drives, drive controllers (including controllers that are integrated
on the system board assembly), drive backplanes or drive cables, back up all important data that is stored
on drives.
• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
Note: Make sure you have the drive bay fillers available if some drive bays will be left empty after the
removal.
Watch the procedure
A video of this procedure is available at YouTube:
AgTVLhsU24Nhel3_oYlnGT
Procedure
Step 1. Slide the release latch to unlock the drive handle.
Step 2. Rotate the drive handle to the open position.
Step 3. Grasp the handle and slide the drive out of the drive bay.
Figure 119. 2.5-inch hot-swap drive removal
After you finish
Note: Install a drive bay filler or replacement drive as soon as possible. See
drive" on page 157.
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install a 2.5-inch hot-swap drive
Follow instructions in this section to install a 2.5-inch hot-swap drive.
About this task
.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
"Install a 2.5-inch hot-swap
.
Chapter 5 Hardware replacement procedures
157