Lenovo ThinkSystem SR675 V3 User Manual page 143

b. Disconnect the serial port cable from the system board assembly.
c. Remove the PCIe riser where the serial port module has been installed. See
riser" on page
Step 2. Remove the serial port module.
a. Remove the serial port cable from the cable clip.
b. Open the retention latch on the PCIe riser.
c. Unfasten the screw that secures the serial port module to the PCIe riser.
d. Remove the serial port module from the PCIe riser.
Figure 100. Serial port module removal
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the serial port module
Follow instructions in this section to install the serial port module.
About this task
Attention: Read "Installation Guidelines" on page 45
that you work safely.
Watch the procedure
A video of this procedure is available at YouTube:
AgTVLhsU24Nhel3_oYlnGT
Procedure
Step 1. Open the retention latch on the PCIe riser.
Step 2. Install the serial port module.
a. Insert the serial port module into the PCIe riser.
b. Fasten the screw to secure the serial port module to the PCIe riser.
110.
.
and "Safety inspection checklist" on page 46
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
Chapter 5 Hardware replacement procedures
"Remove a PCIe
to ensure
135