Lenovo ThinkSystem SR675 V3 User Manual page 69

Step 3. From the front of the rack, install server into the rails.
a. Tilt the server and slowly lower the rear end; then, push the rails toward the server and make
sure the farthest nailheads on server's left and right side go into the slots on the rail.
b. Slowly lower the server down and make sure the other 3 nailheads on server's left and right
side slip into corresponding slots.
Note: Inspect the sides of the rails to make sure the nailheads are placed in the slots.
Attention: You can only install the server successfully when the rails are fully extended.
Rack front
Figure 28. Installing the server into the rails
Step 4. Slide the server into rack.
a. Push up the latches on the rails.
b. Push the server all the way into the rack.
.
Chapter 5 Hardware replacement procedures
61