Figure 57. Intrusion switch connector location
Intrusion switch connector
1
After you finish
1. Reinstall the PCIe riser 2 if necessary. See
2. Complete the parts replacement. See
M.2 backplane and M.2 drive replacement
Follow instructions in this section to remove and install the M.2 backplane and an M.2 drive.
Remove an M.2 drive
Follow instructions in this section to remove an M.2 drive.
About this task
Attention:
• Read
"Installation Guidelines" on page 45
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack. See
• If one or more NVMe solid-state drives are to be removed, it is recommended to disable them beforehand
via the operating system.
ThinkSystem SR675 V3 User Guide
92
"Install a PCIe riser" on page
"Complete the parts replacement" on page
and
"Safety inspection checklist" on page 46
54.
"Remove the server from rack" on page
115.
194.
to ensure that you
54.