4-Dw Gpu Model Cable Routing - Lenovo ThinkSystem SR675 V3 User Manual

4-DW GPU Model cable routing

Follow the instructions in this section to learn how to do cable routing for the 4-DW GPU Model.
Notes:
1. Go through the following sections in
information before starting cable routing.
2. Make sure to remove the top of the cross bar before routing the cables.
3. Make sure to route the cables through cable guide and cable clip as instructed in the cable routing
guides. See the illustration below for the cable guide and cable clip locations.
Figure 167. Cable guide and cable clip locations in the chassis
Refer to the corresponding cable routing guide for related components:
• "2.5-inch drive backplane cable routing" on page 201
• "Front I/O expansion board cable routing" on page 201
• "Front I/O module cable routing" on page 202
• "GPU adapter power cable routing" on page 203
• "GPU distribution board cable routing" on page 205
• "OCP module cable routing" on page 205
ThinkSystem SR675 V3 User Guide
200
"Identifying connectors" on page 195 to acquire necessary