Gpu Air Duct Replacement - Lenovo ThinkSystem SD530 V3 User Manual

Attention:
• Read "Installation Guidelines" on page 41
you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
node and chassis; then, take the component out of the package and place it on a static-protective
surface.
Procedure
Step 1. Install the fan.
a. Align the fan with the fan slot in the fan cage as illustrated; then, lower and press the fan into
the fan slot until it is securely seated.
b. Connect the fan cable to the system board. See
c. Insert the four rivets on the top side from the exterior of the fan cage to secure the fan to the
fan cage.
Figure 47. Fan installation
After this task is completed
1. Make sure that all the required cables are routed and connected correctly; then, reinstall the top cover
(see "Install the top cover" on page
2. Reinstall the node into the chassis (see
3. Make sure that the required power supply units are installed and power cords are connected; then,
power on the node (see
51.)
4. Proceed to complete the parts replacement (see

GPU air duct replacement

Follow instructions in this section to remove or install the GPU air duct.
Note: Depending on the specific configuration, the node might not come with this component.
Remove the GPU air duct
Follow instructions in this section to remove the GPU air duct.
About this task
and "Safety inspection checklist" on page 42
170).
"Install a node to the chassis" on page
"Install a hot-swap power supply" on page 61
"Fan cable routing" on page
and
"Complete the parts replacement" on page
.
Chapter 5 Hardware replacement procedures
to make sure that
176.
75).
"Power on the node" on page
171).
91