Lenovo ThinkSystem SR675 V3 User Manual page 101

• Before you remove or make changes to drives, drive controllers (including controllers that are integrated
on the system board assembly), drive backplanes or drive cables, back up all important data that is stored
on drives.
• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
Watch the procedure
A video of this procedure is available at YouTube:
AgTVLhsU24Nhel3_oYlnGT
Procedure
Step 1. Remove the top cover. See
Step 2. Remove the M.2 drive.
a. Press the retainer from the both sides.
b. Slide the retainer away from the M.2 drive
c. Rotate the rear end of the M.2 drive to an angle.
d. Remove the M.2 drive from the M.2 backplane.
Figure 58. M.2 drive removal
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Remove the M.2 backplane
Follow instructions in this section to remove the M.2 backplane.
About this task
Attention:
• Read "Installation Guidelines" on page 45
work safely.
.
"Remove the top cover" on page
and "Safety inspection checklist" on page 46
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
154.
.
Chapter 5 Hardware replacement procedures
to ensure that you
93