Note: An E3.S drive in bay 2 or 3 is used as an example in the illustration. The orientation of
E3.S drives in bay 0 and 1 is upside down, but the installation method is the same.
Figure 134. E3.S hot-swap drive installation
Step 4.
If you have additional drives to install, do so now; if any of the drive bays is left empty, fill it with a
drive bay filler.
Step 5.
Check the drive status LED to verify that the drive is operating correctly.
• If the yellow drive status LED is lit continuously, the drive is malfunctioning and must be
replaced.
• If the green drive activity LED is flashing, the drive is functioning.
Step 6.
Reinstall the EDSFF drive cage cover back to the server.
Figure 135. EDSFF drive cage cover installation
After you finish
.
Chapter 5
Hardware replacement procedures
169