Lenovo ThinkSystem SR675 V3 User Manual page 166

Attention:
• Read "Installation Guidelines" on page 45
work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
• Make sure you save the data on your drive, especially if it is part of a RAID array, before you remove it
from the server.
• To avoid damage to the drive connectors, make sure that the server top cover is in place and fully closed
whenever you install or remove a drive.
• To make sure that there is adequate system cooling, do not operate the server for more than two minutes
without either a drive or a drive bay filler installed in each bay.
• Before you make changes to drives, drive controllers (including controllers that are integrated on the
system board assembly), drive backplanes, or drive cables, back up all important data that is stored on
drives.
• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
The following notes describe the type of drives that the server supports and other information that you must
consider when you install a drive. For a list of supported drives, see
• Locate the documentation that comes with the drive and follow those instructions in addition to the
instructions in this chapter.
• The electromagnetic interference (EMI) integrity and cooling of the solution are protected by having all
bays and PCI and PCIe slots covered or occupied. When you install a drive, PCI, or PCIe adapter, save the
EMC shield and filler panel from the bay or PCI or PCIe adapter slot cover in the event that you later
remove the device.
• For a complete list of supported optional devices for the server, see
• The 4-DW GPU Model supports up to eight 2.5-inch hot-swap SAS/SATA/NVMe drives with the following
corresponding drive bay numbers.
Figure 120. 2.5-inch drive bay numbering in 4-DW GPU Model
Firmware and driver download: You might need to update the firmware or driver after replacing a
component.
• Go to
https://datacentersupport.lenovo.com/tw/en/products/servers/thinksystem/sr675v3/7d9q/downloads/
driver-list/ to see the latest firmware and driver updates for your server.
• Go to "Update the firmware" on page 217
Watch the procedure
A video of this procedure is available at YouTube:
AgTVLhsU24Nhel3_oYlnGT
ThinkSystem SR675 V3 User Guide
158
and "Safety inspection checklist" on page 46
for more information on firmware updating tools.
.
https://serverproven.lenovo.com
https://serverproven.lenovo.com
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
to ensure that you
.
.