Front I/O Module Replacement - Lenovo ThinkSystem SR675 V3 User Manual

Figure 48. Flash power module installation
Step 6. Connect the cable to the corresponding RAID adapter.
After you finish
1. Reinstall the PCIe riser. See
2. Complete the parts replacement. See

Front I/O module replacement

Follow instructions in this section to remove or install the front I/O module.
Remove the front I/O module
Follow instructions in this section to remove the front I/O module.
About this task
Attention:
• Read "Installation Guidelines" on page 45
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack. See
Watch the procedure
A video of this procedure is available at YouTube:
AgTVLhsU24Nhel3_oYlnGT
Procedure
Step 1. Remove the top cover. See
Step 2. Disconnect the front USB, video and external diagnostics handset cables of the front I/O module
from their respective connectors on the system board assembly. See
connectors" on page 26
Step 3. Remove the front I/O module
a. Remove the front I/O module retention screw.
b. Lift the front I/O module out of the chassis.
"Install a PCIe riser" on page
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 46
54.
"Remove the server from rack" on page
.
"Remove the top cover" on page
for more details.
115.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
154.
.
Chapter 5 Hardware replacement procedures
194.
to ensure that you
54.
"System-board-assembly
83