Lenovo ThinkSystem SR675 V3 User Manual page 99
Hide thumbs
Also See for ThinkSystem SR675 V3:
- Manual (200 pages) ,
- System configuration manual (86 pages)
Table of Contents
Advertisement
Install the intrusion switch
Follow instructions in this section to install the intrusion switch.
About this task
Attention:
• Read
"Installation Guidelines" on page 45
work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Watch the procedure
A video of this procedure is available at YouTube:
AgTVLhsU24Nhel3_oYlnGT
Procedure
Step 1.
Push the intrusion switch into the intrusion switch bracket on the top of the power supply bays.
Make sure the intrusion switch is fully seated in the bracket.
Step 2.
Route the intrusion switch cable through the three cable clips on the outside of the power supply
bays.
Step 3.
Connect the intrusion switch cable to the system board assembly.
Figure 56. Intrusion switch installation
and
"Safety inspection checklist" on page 46
.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
Chapter 5
Hardware replacement procedures
to ensure that you
91
Advertisement
Table of Contents
Troubleshooting
