Table of Contents
Advertisement
Step 6: Cutting
Send Print & Cut data to the machine, and start cutting.
WARNING
Never touch the cutting carriage while output is in progress.
The cutting carriage moves at high speed. Coming into contact with the moving carriage may cause injury.
Procedure
1.
Click
.
The [Cut ]window is displayed.
2.
Click [OK].
The Print & Cut data is sent to the machine. When the machine receives the Print & Cut data, it
automatically reads the crop marks using a sensor, and then starts cutting.
MEMO
If the sensor fails to read the crop marks, the screen shown below appears.
If the following screen appears, refer to
SET TO
<TOOL MODE>
If that does not resolve the issue, switch to Tool Mode, and then perform aligning.
P. 173Print & Cut in Tool Mode
Crop Marks Are Not Detected(P. 286)
Printing and Cutting Method
to resolve the error.
Creating Cut Data Using CutStudio
77
Advertisement
Table of Contents
