Are The Size And Shape Of Crop Marks Correct; Are The Crop Marks At The Correct Positions; Is The "Rotate" Menu Set To "90Deg; Is The Machine Exposed To Direct Sunlight Or Strong Indoor Lighting - Roland VersaSTUDIO GS2-24 User Manual

Are the size and shape of crop marks correct?

The machine can only detect crop marks in the prescribed shape.
Make the crop marks as perfect circles of 10 mm (0.39 in.) in diameter.
RELATED LINKS
・
P. 16Crop Marks

Are the crop marks at the correct positions?

Place the crop marks at the correct positions.
RELATED LINKS
・
P. 329Margins and the Distance between Crop Marks

Is the "ROTATE" menu set to "90deg"?

When using crop marks, be sure to set the "ROTATE" menu to "0deg". Crop marks cannot be read if set to
"90deg".
RELATED LINKS
・
P. 202Set the Orientation of Cutting Coordinates

Is the machine exposed to direct sunlight or strong indoor lighting?

If the cutting carriage sensor is exposed to direct sunlight or indoor lighting, crop marks may not be de-
tected.
Move the machine to a location where it is not exposed to direct sunlight or indoor lighting.
If the issue is not resolved even after taking the steps above, perform aligning with "TOOL MODE".
RELATED LINKS
・
P. 173Print & Cut in Tool Mode
Is the material loaded and set up straight and securely? Are the printing results
crooked?
Crop marks cannot be detected in the following cases: Ensure that the material is loaded or printed with
straight crop marks.
• The left and right crop marks are slanted by 5 degrees or more with respect to the moving direction of
the cutting carriage.
• The crop marks are offset by 20 mm in the material-feed direction.
RELATED LINKS
・
P. 68Load the printed material
Crop Marks Are Not Detected
Cutting Problems
287