Preventing and Correcting Misaligned Cutting
Using Thinner or Harder Material than Normal
Turn on the suction fan to hold the material in place during cutting so as to prevent the material from lift-
ing up or moving out of place. Normally use "AUTO" as is. However, the air volume of the suction fan should
be lowered when using materials that are thin and/or not firm.
Procedure
1.
Press [MENU] several times to display the following screen.
CONDITION
MEMO
When the material is loaded, press [MENU] several times to display the following screen.
UNSETUP
2.
Press [▼] several times to display the following screen.
OTHERS
3.
Press [▶].
4.
Press [▲][▼] to display the following screen.
VACUUMFAN AUTO
5.
Press [▶].
6.
Press [▲] or [▼] to select a value.
Use a weaker air volume when using thin material.
VACUUMFAN AUTO
*AUTO
7.
Press [ENTER] to select the setting.
8.
Press [MENU] to return to the original screen.
MEMO
• Factory default setting: "AUTO"
• Setting range: 1 to 5, "AUTO"
212
Optimizing Cutting Quality