Table of Contents
Advertisement
Adjusting the Cut Setting
Setting the Blade Force
If the design peels off or if the carrier paper is also cut with the material, change the blade force.
Procedure
1.
Check that the PEN FORCE slider [PEN FORCE] is at the center position (at "0" on the scale).
▲
▲
2.
Press [FORCE].
The current blade force is displayed.
FORCE 50gf
* 50gf
3.
Press [▲] or [▼] to select a value.
4.
Press [ENTER] to select the setting.
MEMO
• Factory default setting: 50 gf
• Setting range: 30 to 500 gf (can be changed in 10 gf steps)
RELATED LINKS
・
P. 196General Guide Regarding Cutting Conditions
Fine-tuning the Blade Force
After you set the blade force using the "FORCE" menu, you can further fine-tune the blade force using the
PEN FORCE slider. "FORCE"Use this operation when you want to make the blade force slightly larger or
smaller than the setting made using the menu.
Procedure
1.
Adjust the blade force with the PEN FORCE slider.
▲
▲
• Adjustable range: ±Approximately 30 gf
198
Optimizing Cutting Quality
-2
-1
0
+1
+2
-2
-1
0
+1
+2
Advertisement
Table of Contents
