Table of Contents
Advertisement
Step 3: Cutting
Send the cut data to the machine, and cut the material.
IMPORTANT
If the material comes off or the machine operates abnormally, press [PAUSE] to cancel the output.
Lower the loading lever, take out the material, and perform the setup again from the beginning.
WARNING
Never touch the cutting carriage while output is in progress.
The cutting carriage moves at high speed. Coming into contact with the moving carriage may cause injury.
Procedure
1.
On the [Roland CutStudio] palette, select [Output All Lines], and then click [Update].
Confirm that the cutting line to output is displayed on the preview screen.
2.
On the palette, click
3.
Select [Roland GS2-24], and click [Cut].
Cutting starts.
If the model name does not appear, refer to
4.
After cutting is finished, click [Exit] to close the window.
.
The Machine Doesn't
Run.
Creating Cut Data Using Adobe Illustrator (Mac)
Cutting Method
121
Advertisement
Table of Contents
