Power On; Perform Test Cutting - Roland Stika Plus STX-8 User Manual

Align the marks on the sheet setup guide with the left and
2
right edges of the blade protector. At the same time, align
the tip of the sheet setup guide with the tip of the blade
protector and affix.
Align the guide lines on the sheet setup guide with the left
and right edges of the material, and turn the sheet feed
knob.
* Depending on the material width, the left and right edges
may not be perfectly aligned.
4

Power ON!

Close the front cover and press the STANDBY key.
1
The STANDBY LED lights up and the carriage moves as
2
shown in the figure, then stops.
5

Perform Test Cutting

NOTICE
Be sure to load a piece of material, or the pinch rollers may be damaged.
Do not move the carriage by hand. Doing so may result in breakdown.
Do not attempt to move the carriage by hand.
6
Blade protector
Sheet setup guide
Guide lines
Material
Front cover
* Slight noise may be heard when the
carriage changes direction.
STANDBY key