Table of Contents
Advertisement
Checking the Display Menu
"OTHERS"
You can set the display, or turn other settings on or off.
• "SMOOTHING"
SMOOTHING ON
You can set the curves in cutting data sent to this machine to be smooth.
P. 207Smoothly Cutting Arcs and Other Curves (Smoothing)
• "UNIT"
UNIT mm
You can set the unit for the display.
P. 267Changing the Unit of Length to Be Displayed
• "FACTORYDEFAULT"
FACTORYDEFAULT
This procedure returns all settings to their factory default values. Any setting made to this point
will be deleted. Keep a record of any necessary information such as cutting conditions.
P. 270Restoring Default Settings
• "CONTRAST"
CONTRAST 5
You can adjust the brightness of the display. Change the setting for the ease of looking at the dis-
play according to your environment.
P. 269Adjusting the Brightness of the Display
• "VACUUMFAN"
VACUUMFAN AUTO
Turn on the suction fan to hold the material in place during cutting so as to prevent the material
from lifting up or moving out of place. When using materials that are thin and/or not firm, it is
recommended to lower the air volume of the suction fan.
P. 212Using Thinner or Harder Material than Normal
• "PRE-FEED"
PRE-FEED OFF
Material is automatically fed before and during cutting in order to avoid misalignment of cutting
positions. This setting is useful especially when cutting data that is 1 m (3.28 ft.) or larger.
P. 213Preventing Misaligned Cutting
• "OVER CUT"
OVER CUT OFF
This function cuts extra at the start and the end of a cutting line. It is effective when you want to
produce particularly sharp corners, for example when cutting thicker materials.
24
Basic Operation
Advertisement
Table of Contents
