Part 2 Performing Cutting; Load The Material - Roland Stika SX-15 User Manual

Part 2 Performing Cutting

2.1

Load the Material

1 Place the material against the pinch rollers.
Load the material as shown in the figure, so that it does
not come loose during cutting.
2 Turn the sheet feed knob to align the forward edge of the
material with the back of the blade protector.
Do not use any of the following materials. The material may come loose during cutting or otherwise fail to be fed
properly.
Materials which has
curled upward
Pinch rollers
Sheet feed knob
Material with a front
edge that is not
straight
Make sure the two sides of the material are even.
Blade protector
Material with left and
right edges that are
not parallel
Part 2 Performing Cutting
Material that is
longer than 1110 mm
(43-1/4 in.)
2-1